I did notice 4 wires that were completely wrapped in black electrical tape.

In regard to the diode, I couldnt find it although I peeled back quite a bit ofĮlectrical tape from the connector back. In fact, it seems as though I'm getting the dreaded pedal 'pulsing' quite a bit more lately. No luck.ABS light is still on the whole time you're driving down the road.

I ran a ground wire from the ECBM housing to body ground. If I was getting that, I'd try just adding a ground wire right at the EBCM mount but 4.4 ohms should not bother it. Connector is shown in figure 5E1-16 See also 'system diagnosis chart B 'Anti-Lock' Lamp on and no abs codes present. If you have a resistive ground things will be wonky. Pin 1 on the EBCM connector is to ground. Oh, and by the way.why does everybody (including the manual) say the ABS light is AMBER? It is not!!!!! It is green dang it! How can there be no codes yet have an ABS light? That's pretty weird that all of a sudden there are no trouble codes!įunny thing is.my ABS light still does the same thing it's always done:Ī) start the car (no ABS light) step on brake (ABS light comes on and stays on all the time from that point on) (for the pinouts the manual said to check) Anyways, after this I reset the ECBM, took it for a short drive (over 40 mph) and re-read the codes. Recently I had been getting a code 13 and 22 but I heard 13 doesnt exist! So.I focused on the known code (22) and verified that I do

Been trying to get that dang ABS light off for 2 years now.Īs I previously mentioned in another thread I had been getting randomīrake failure (and I do mean random) so I have not been driving it.Īs I have time I try to get in there and take a few cracks at it.

Bendix abs flashing